– 5 –
CLEANING
This machine must be thoroughly cleaned and
sanitized after each day’s operation or after being idle
for an extended period of time.
WARNING
: THE SLICER KNIFE IS VERY
SHARP. EXERCISE EXTREME CAUTION WHEN
WORKING NEAR THE KNIFE.
WARNING
: UNPLUG MACHINE POWER CORD
AND TURN THE INDEX KNOB FULLY CLOCKWISE
BEFORE CLEANING THE SLICER.
Use a clean cloth soaked in mild detergent and warm water to wipe all surfaces of the machine.
Rinse using a fresh cloth and clean water. Use only products formulated to be safe on stainless
steel or aluminum.
To clean the Carriage Tray, close the gauge plate and pull the Carriage all the way to the front.
Unscrew the Knob on the Carriage Tray / Support Arm (Fig. 3). Tilt the Carriage Tray / Support
Arm to the right until almost horizontal (Fig. 3). The Carriage Tray / Support Arm can be cleaned
while in this horizontal position, or it can be removed by grasping with both hands and lifting
straight up. Once removed, the Carriage Tray / Support Arm can be cleaned in a sink. NOTE: The
last three digits of the slicer serial number are etched on the Key (Fig. 7) so you can make sure
the Carriage Tray stays with its own slicer.
Remove the Top Knife Cover by rotating the Latch Knob (Fig. 3) counterclockwise and lifting it
free of the guide pins. Remove the Deflector (Fig. 1) from its mount below the slicer knife by rotating
downward. Clean both Top Knife Cover and Deflector with warm soapy water in a sink. Rinse
with clean water.
Remove the sharpener by pushing the Lock Lever to the left (Fig. 4). Tilt the right side up, clearing
the right guide pin, then lift the sharpener up, clearing the left guide pin. Wipe out any residue
remaining inside the sharpener housing and clean the sharpener in a sink. Rinse with fresh water.
Clean completely around the Ring Guard by working a moistened, folded paper towel between
the Ring Guard and Knife. Insert the towel at the base of the Ring Guard. Manually rotate the knife
and the towel will wipe the Ring Guard and the edge of the Gauge Plate as it follows the knife
(Fig. 5).
PL-41402-1
GAUGE PLATE
KNIFE
SHARPENER
LOCK LEVER
PL-41403-1
GAUGE PLATE
KNIFE
RING GUARD
PAPER TOWEL
Fig. 4 Fig. 5
PL-41252-1
LA
TCH KNOB
TOP KNIFE COVER
CARRIAGE TRAY /
SUPPORT ARM
CARRIAGE TRAY
KNOB
Fig. 3
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals