701 S. RIDGE AVENUETROY, OHIO 45374-0001NSTRUCTIONSIFORM 33966 Rev. A (11-98)MODEL FP400 FOOD PROCESSORML-104751
– 10 –Pusher Plate(Use the decoring screw to secure the plates to the knife shaft.)1. Press the STOP button.2. Fit the feed cylinder with three intern
– 11 –USING THE FOOD PROCESSORWhen using the feed hopper attachment, bulk product may be added to the feed hopper duringoperation.When using the pushe
– 12 –Crimping Slicer3⁄16 CR (4.5 mm) Ripple cuts root vegetables (beets,potatoes, carrots, etc.)Julienne CuttersJulienne Cutter3⁄32 (2.5 mm)Julienne
– 13 –CLEANINGWARNING: TURN THE MACHINE OFF AND UNPLUG THE ELECTRICAL CORD BEFORE CLEANING.Clean the machine immediately after each use. Dismantle a
– 14 –2. Remove the feed cylinder. The feed cylinder guides (see Fig. 7) OR the three knives (see Fig. 8)may be removed for cleaning by unscrewing th
– 15 –TROUBLESHOOTINGSYMPTOMMachine will not start or stopswhile operating and won't restart.Low output or poor cutting results.POSSIBLE CAUSE1.
– 16 –SYMPTOMCutting tool locked to shaft.Decoring screw or agitator devicecannot be removed.POSSIBLE CAUSEBuild-up between cutting tool anddicing gri
– 2 –TABLE OF CONTENTSMODEL FP400 FOOD PROCESSOR ... 3GENERA
– 3 –© HOBART CORPORATION, 1998MODEL FP400 FOOD PROCESSOR(Shown with Feed Hopper Attachment)
– 4 –Installation, Operation and Care ofHOBART MODEL FP400 FOOD PROCESSORPLEASE KEEP THIS MANUAL FOR FUTURE USEGENERALThe FP400 Food Processor is used
– 5 –VERIFY CORRECT ROTATIONVerify correct rotation of the knife shaft. Make sure it moves in a clockwise direction looking down intothe feed cylinde
– 6 –OPERATIONWARNING: ROTATING KNIVES INSIDE. ALWAYS USE THE FEED HOPPER OR PUSHER PLATEFEED ATTACHMENT. KEEP HANDS OUT.Proper assembly of the FP4
– 7 –INSTALLING THE CUTTING TOOLSAlways push the red STOP button before changing cutters.Slicing, Shredding, Grating, and Julienne Cutting1. Pull the
– 8 –4. Screw the decoring screw (if using the pusher plate feed attachment) (left-hand thread) OR theagitator device (if using the feed hopper attach
– 9 –Fig. 7INSTALLING AND REMOVING THE FEED ATTACHMENTSThe feed hopper attachment (Fig. 7) is used mainly for cutting round products up to 3" (76
Comments to this Manuals