Hobart ML-104586 User Manual

FP350 FOOD PROCESSORMODELFP350 ML-104586FOOD PROCESSORS701 S. RIDGE AVENUETROY, OHIO 45374-0001937 332-3000www.hobartcorp.comFORM 19353 Rev. D (Oct. 2

– 10 –Dicer and French Fry PlatesThe recommended slicer plate will produce near cube-shaped products.The DICER grid dimension must be equal to or larg

– 11 –MAINTENANCEWARNING: TURN THE MACHINE OFF AND UNPLUG THE ELECTRICAL CORD BEFORE DOINGANY MAINTENANCE.Routinely inspect the machine to make sure

– 12 –FORM 19353 Rev. D (Oct. 2000) PRINTED IN U.S.A.SERVICEContact your local Hobart Service Office for any repairs or adjustments needed on this equ

– 2 –© HOBART CORPORATION, 1995TABLE OF CONTENTSGENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

– 3 –Installation, Operation, and Care ofMODEL FP350 FOOD PROCESSORSAVE THESE INSTRUCTIONSGENERALThe FP350 Food Processor is used for slicing, shreddi

– 4 –Fig. 1

– 5 –OPERATIONWARNING: ROTATING KNIVES INSIDE. ALWAYS USE PUSHER PLATE. KEEP HANDS OUT.Proper assembly of the FP350, including selection of the app

– 6 –3. To remove the pusher plate, hold the pusher plate handle, raise the pusher plate and swing it outto the left so that the feed cylinder is set

– 7 –Removing the Cutting Tools1. Using the pusher plate handle, raise the pusher plate and swing it out to the left so that the feedcylinder is set i

– 8 –CLEANINGWARNING: TURN THE MACHINE OFF AND UNPLUG THE ELECTRICAL CORD BEFORE CLEANING.Clean the machine immediately after each use. Dismantle a

– 9 –CUTTING TOOL GUIDE Fractional sizes are in inches (millimeters are in parentheses).Slicers Use Fine and Standard Slicers for sliced products and