Hobart H600 User Manual

701 S. RIDGE AVENUETROY, OHIO 45374-0001937 332-3000www.hobartcorp.comNSTRUCTIONSIFORM 34816 (Aug. 2002)H600 MIXERH600 & L800 MIXERSMODELSH600 ML

– 10 –-P1-P201:00- - - -1 2 3 4Indicators above P1and 1 indicate thefirst preset timecontained in P1.Revise Preset Mixing Times (Preset Keys P1 or P2)

– 11 –STANDARD BOWL LIFTThe Hand-wheel is used to raise and lower the bowl on mixers with the standard bowl lift. Turn the Hand-wheel clockwise to rai

– 12 –WIRE CAGE ASSEMBLY (Before September, 2002 Production Fig. 5)The Wire Cage Assembly can be rotated out of the way to add ingredients or to acces

– 13 –WIRE CAGE ASSEMBLY (After September, 2002 Production Fig. 6)The Wire Cage Assembly can be rotated out of the way to add ingredients or to access

– 14 –Remove Wire Cage Assembly (Fig. 7)1. Lower the bowl. Remove the Accessory and bowl.2. While holding the Wire Cage securely with both hands, rota

– 15 –ATTACHMENTSTo install an attachment, loosen the attachment hub thumb screw and remove the plug. Insert theattachment into the Attachment Hub, ma

– 16 –MAINTENANCEWARNING: DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND FOLLOWLOCKOUT / TAGOUT PROCEDURES.LUBRICATIONPlanetary (Before September,

– 17 –TransmissionThe transmission oil should be even with the line on the oil level gauge when the motor is not running.If the oil falls below this l

– 18 –Bowl ClampsThe height of the Bowl Clamp is controlled by a spring washer and lock nut, which are located on thebottom of the Bowl Support. Turn

– 19 –TROUBLESHOOTINGSYMPTOMS POSSIBLE CAUSESMixer will not start. 1. Gear Shift Lever between gears (not fully engaged).2. Circuit protector in open

– 2 –© HOBART CORPORATION, 2002Model H600 Mixer Model L800 Mixer

– 20 –FORM 34816 (Aug. 2002) PRINTED IN U.S.A.NOTES

– 3 –TABLE OF CONTENTSGENERAL ...

– 4 –Installation, Operation and Care ofH600 and L800 MIXERSSAVE THESE INSTRUCTIONSGENERALModel H600 is a heavy-duty 60-quart mixer which features a t

– 5 –INSTALLATIONUNPACKINGImmediately after unpacking the mixer, check for possible shipping damage. If this machine is foundto be damaged after unpac

– 6 –ELECTRICAL CONNECTIONSWARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THEAPPLICABLE PORTION OF THE NATIONAL ELECTRICAL CODE AND/OR

– 7 –PL-40067-1ContolsGear Shift LeverHandwheelApronAgitatorBowl ClampBowl SupportBowlBowl HandleBowl ScraperAttachment (optional)Bowl GuardAttachment

– 8 –PROGRAMMABLE TIMER CONTROLLER (When Equipped)At idle, the timer display [- - : - -] shows that no time has been set (Fig. 4).Fig. 4Timer Keys Pro

– 9 –Set Mixing Time (Preset Keys P1 or P2)Each preset key has four time settings. The indicator lights above the number 1, 2, 3 or 4 and the P1or P2