Hobart 5212F User Manual download pdf (Page 6)

– 6 –

BLADE GUIDE

The blade guide in the lower guide and wiper assembly (Fig. 3) is available in additional sizes if using

other than the standard .020" blade. Contact Service to change the blade guide for other widths.

ELECTRICAL CONNECTION

WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE

APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL

ELECTRICAL CODES.

WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE

DISCONNECT SWITCH INDICATING THAT THE CIRCUIT IS BEING WORKED ON.

ELECTRICAL DATA

Model Volts / Hertz / Phase

Fuse Circuit Breaker

Minimum

Circuit Ampacity

AMPS

Maximum

Fuse Size

AMPS

Minimum

Circuit Ampacity

AMPS

Maximum

Circuit Breaker Size

AMPS

5212

5212F

115 / 60 / 1 40 40 40 40

200 - 230 / 60 / 1 25 25 30 30

200 - 230 / 60 / 3 15 15 20 20

460 / 60 / 3 15 6 15 10

Compiled in accordance with the National Electrical Code, ANSI / NFPA 70, 1993 Edition.

Remove the motor access panel (Fig. 5) on the left side of the meat saw (14 screws).

A 1

/32" diameter hole for

/4" trade size conduit is located in the lower area of the base. Use watertight

connections. Refer to Electrical Data, the machine data plate (Fig. 5), and the wiring diagram located

inside the motor access panel when making the electrical connection. Use copper wire rated at least

75°C for the connection.

CHECK MOTOR ROTATION (Three-Phase Machines)

If the motor does not rotate so the teeth of the saw blade run downward as you look at the cutting zone,

correct the rotation using the following procedure:

WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE

DISCONNECT SWITCH INDICATING THAT YOU ARE WORKING ON THE CIRCUIT.

Interchange any two of the incoming power supply leads. Reconnect the power supply and turn

the saw momentarily on and off to verify correct rotation.

Replace the motor access panel (14 screws).

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Hobart 5212F User Manual Page 6

Comments to this Manuals

Related products and manuals for Mincers Hobart 5212F