Hobart LT1 ML-104239 User Manual download pdf (Page 4)

– 4 –

PL-40920-1

FRONT RACK TRACK

AND SPLASH GUARD

SCREWS

INSTALLATION

UNPACKING

Immediately after unpacking the dishwasher, check it for possible shipping damage. If this machine

is found to be damaged, save the packaging material and contact the carrier within 15 days of delivery.

Prior to installation, verify that the electrical service agrees with the specifications on the machine data

plate which is located to the right of the control box.

LOCATION

Before finalizing machine location, make sure that consideration has been given for water supply, drain

connection, electrical conduit, tabling, chemical containers and supply lines, as well as adequate

clearance for opening the doors. A hood or vent may be required in order to meet local codes.

LEVELING

The dishwasher must be level before any connections are made. With the dishwasher in its operating

location, turn the threaded feet as required to level the machine front-to-back and side-to-side.

CONVERTING FROM STRAIGHT-THROUGH TO CORNER OPERATION

The LT1 is shipped from the factory for straight-

through operation. To convert to corner operation,

move the rack track and splash guard as follows:

1. Remove the two screws and nuts that secure

the front rack track and splash guard (Fig. 1)

and remove the front rack track and splash

guard. Reassemble the front rack track and

splash guard by replacing the two screws and

nuts in the same mounting holes from which

they were removed.

2. Remove the two screws and nuts at the outer edges of the splash guard (Fig. 2).

3. With the two screws and nuts removed in step 2, reattach the front rack track and splash guard to

the left side of the rack track assembly, using the mounting holes (Fig. 3) provided.

Fig. 2 Fig. 3

Fig. 1

PL-40920-2

SCREWS

PL-40921-1

MOUNTING HOLES

1 2 3 4 5 6 7 8 9 ... 15 16

No comments

Hobart LT1 ML-104239 User Manual Page 4